Summary of Polishing Process of Rice Processing Equipment
Summary of rice polishing process in rice processing equipment.
1. Check the V belt of rice processing equipment for proper tension. If the tension is not enough, the V belt slips and the tension is too large, the service life of bearing and V belt will be reduced. Even causes the machine the breakdown and the damage.
2. During no-load operation, check whether the bearing is overheated, whether the machine has abnormal vibration and noise, and whether the motor current increases abnormally.
3. Adjust the air pressure: adjust the connecting air pressure to about 0.2MPa.
4.Rice wather polisher need adjust the water pressure: turn on the water pump and adjust the water pressure to about 2kg / C ^, which can be displayed by the water pressure gauge.
5. Start the fan on the air network.
6. Put the raw material into the feed hopper and start the motor of the main engine.
7. Pull the plug board to adjust the flow to the required output (about 3500kg-5000kg / h).
8. Adjusting the weight produces a slight resistance.
9. Start the water pump and slowly turn the adjusting knob of the water flow meter to set the water flow regulation properly.
10. A grasp, rice twist into a small ball, loose after the rice naturally scattered, indicating that the amount of water is appropriate; If the rice is twisted into a big ball and does not disperse after loosening, it means that the amount of water is excessive, so the amount of water should be reduced; On the contrary, if the rice emits dark, it means that the water is insufficient, then the amount of water should be increased.
11. Move the weight to increase the resistance and adjust it to the best state. At this time, even if the resistance is increased, the luster of rice will not be improved.
More Details please visit roller rice mill whitener http://www.goldengrainmill.com/product/horizontal-single-roller-rice-polisher for reference. Welcome to contact us.
